Metabolic studies have shown that there is a metabolic cost associated with carrying load (T. M. Griffen, et al., 2003). In previous work, a lightweight, underactuated exoskeleton has been described that runs in parallel to the human and supports the weight of a payload (C. J. Walsh, et al., 2006). A state-machine control strategy is written based on joint angle and ground-exoskeleton force sensing to control the joint actuation at thisexoskeleton hip and knee. The joint components of the exoskeleton in the sagittal plane consist of a force-controllable actuator at the hip, a variable-damper mechanism at the knee and a passive spring at the ankle. The control is motivated by examining human walking data. Positive, non-conservative power is added at the hip during the walking cycle to help propel the mass of the human and payload forward. At the knee, the damper mechanism is turned on at heel strike as the exoskeleton leg is loaded and turned off during terminal stance to allow knee flexion. The passive spring at the ankle engages in controlled dorsiflexion to store energy that is later released to assist in powered plantarflexion. Preliminary studies show that the state machines for the hip and knee work robustly and that the onset of walking can be detected in less than one gait cycle. Further, it is found that an efficient, underactuated leg exoskeleton can effectively transmit payload forces to the ground during the walking cycle.

(далее…)

Категория: Научные статьи | Нет комментариев »

Using CMU actuators, a Prototype of Mechanical Assistance Device for the Wrist’s Flexion Movement (PMA) was developed and probed in a mechanical model, in order to be implemented in a future as a dynamic powered orthosis or as a rehabilitation assistant instrument. Two Mayor Actuators conformed by three CMU actuators arranged in a series configuration, allows to an artificial hand to be placed in four predefined positions: 0º, 20º, 40º and 60º. The synchronism and control of the actuators is achieved with the Programmable Control Module (PCM). It is capable to drive up to six CMU actuators, and possess two different modes of execution: a Manual mode and an Exercise mode. In the Manual Mode, the position of the hand responds directly to the commands of the keyboard of the front panel, and in the Exercise mode, the hand realizes a repetitive and programmed movement. The prototype was tested in 100 positions in the Manual Mode and for 225 works cycles in the Exercise Mode. The relative repetition error was less than 5% for both test. This prototype only consumes 4,15W, which makes it possible to be powered by small rechargeable batteries, allowing its use as a portable device.

(далее…)

Категория: Научные статьи | Нет комментариев »

A novel multi-fingered exoskeleton haptic device using passive force feedback has been proposed by the authors. The haptic device solves the conventional problems of previously developed master-slave systems with force feedback, such as oscillations, complex structures and complicated control algorithm. However, some problems still remain in the conventional passive elements. In the present paper, an ultrasonic clutch for multi-fingered exoskeleton haptic device with passive force feedback function is developed. The ultrasonic clutch can solve problems of conventional passive elements, such as time delay, instability, and large size, by using unique characteristics of ultrasonic motor, as fast response, silent motion, and non-magnetic feature. It can also be designed to be smaller than conventional elements due to its simple structure. The clutch locks or releases the rotor by use of ultrasonic levitation phenomenon. First, we have designed the structure of the ultrasonic clutch using an equation of ultrasonic levitation phenomenon, results from structural analysis and finite element (FE) analysis of piezoelectric material of the vibrator. Then we have manufactured the ultrasonic clutch and have conducted a driving experiment. Finally, we have demonstrated that the maximum levitation force is around 20 N and the static friction torque of the ultrasonic clutch is up to 0.14 Nm.

(далее…)

Категория: Научные статьи | Нет комментариев »