The design of a prosthetic device for patients who have suffered loss of muscular control of the hand is described. The authors present some preliminary design considerations, with emphasis on the sensing and actuation systems. The prototype achieves several movements of the fingers of the hand. The design is closely based on the natural human hand to ensure effectiveness and comfort. The exoskeleton is worn as a tight glove, and the joints are flexed by cables and motors. Some preliminary test results are reported.

Категория: Ищем научные статьи | Нет комментариев »

The legs of animals and walking vehicles are subject to substantial changes in loading in climbing over obstacles. Sense organs (campaniform sensilla) on cockroach legs detect these loads through strains in the exoskeleton. Signals that might be sent by the sense organs during climbing were predicted by applying forces to a finite element model of the leg in directions determined from kinematic studies. The model included an accurate, three-dimensional reconstruction of the leg segment (trochanter) that contains an array of these sensors. Calculated strains generated at different phases of climbing suggest that some groups of sensors in the front leg, that show little activity in walking, are strongly activated in climbing. These groups could provide signals to aid in adapting walking patterns to the changing forces encountered in climbing.

(далее…)

Категория: Научные статьи | Нет комментариев »

This correspondence presents a prototype of a powered hand exoskeleton that is designed to fit over the gloved hand of an astronaut and offset the stiffness of the pressurized space suit. This will keep the productive time spent in extravehicular activity from being constrained by hand fatigue. The exoskeleton has a three-finger design, the third and fourth fingers being combined to lighten and simplify the assembly. The motions of the hand are monitored by an array of pressure sensors mounted between theexoskeleton and the hand. Controller commands are determined by a state-of-the-art programmable microcontroller using pressure sensor input. These commands are applied to a PWM driven DC motor array which provides the motive power to move theexoskeleton fingers. The resultant motion of the exoskeleton allows the astronaut to perform both precision grasping tasks with the thumb and forefinger, as well as a power grasp with the entire hand.

(далее…)

Категория: Научные статьи | 1 Комментарий »

This paper considers adding autonomy to robot hands used in teleoperation systems. Currently, the finger positions of robot hands in teleoperation systems are controlled via a robot master using a Dataglove or exoskeleton. There are several difficulties with this approach: accurate calibration is hard to achieve; robot hands have different capabilities from human hands; and complex force reflection is difficult. In this paper we propose a model of hand teleoperation in which the input device commands the motions of a grasped object rather than the joint displacements of the fingers. To achieve this goal, the hand requires greater autonomy and the capability to perform high-level functions with minimal external input. Therefore, a set of general, primitive manipulation functions that can be performed automatically is defined. These elementary functions control simple rotations and translations of the grasped objects. They are incorporated into a teleoperation system by using a simple input device as a control signal. Preliminary implementations with a Utah/MIT are discussed.

(далее…)

Категория: Научные статьи | Нет комментариев »

The control of exploratory and manipulative procedures in teleoperation and virtual environments requires the availability of adequate advanced interfaces capable not only of recording the movements of the human hands and arms, but also of replicating sensations of contact and collisions. In this paper the problem of replicating external forces acting against the remote/virtual arm is addressed. The design of an arm exoskeleton system developed in the authors’ laboratory is presented. The exoskeletonconsists of a 7 DOF actuated and sensorized mechanical structure wrapping up completely the human arm and directly supported by the shoulders and the trunk of the human operator. Emphasis is given to the implemented control procedures and to the description of the transputer-based control architecture.

(далее…)

Категория: Научные статьи | Нет комментариев »